1. The injector Tester 4 pluse Modes Powerful Fuel System Scan Tool, Can help diagnose injector problems, you can use it to test each injector individually to help identify stuck, leaking or burnt-out conditions
2. Injector Tester coms with LED display and 4 pulse modes- Single / Short / Long/ Continuous modes it can help you identify the injector good or not when you switch off the engine.
3. The mode lock feature ensures test condition uniformity.
4. This injector tester with 41.5cm/ 16.3inches test lead can work with any fuel pressure tester. Please NOTE: Gasoline car only,
NOT the diesel engine
Use 12V vehicle battery as power supply
Features
It uses 12V vehicle battery for power.
It has 4 pulse modes, the continuous mode (mode 4) helps identify good or bad injector.
The mode lock feature ensures test condition uniformity.
It can work with any fuel pressure tester.
Operating Instruction
1. Turns off the engine of the car
2. Remove the wire plug with the fuel injector to be tested, and then connect the two pulse output terminals of the instrument with the fuel injector of the vehicle.
3. Connect to the red clip of the instrument to the positive pole of 12 V automobile battery, and connect the black lip of the instrument to the negative pole of the battery.
4. Press “ Mode Set ” key to select the required pulse signal output mode, and the screen will display the currently selected mode.
5. After selecting the required pulse signal output mode, press the “Pulse ” key, the instrument will output pulse to the fuel injector to be tested, and the signal indicator will be on when the pulse is output.
6. After the test is completed, if it is necessary to repeat the test, press the “ Pulse ” key ; if you want to change the pulse , press the “ Reset ” key, you can select the required mode at will, and then test the fuel injector again.
Warning:
1. The engine of the car must be turned off before using this instrument.
2. Do not smoke or ignite near the car.
3. Don’t splash the fuel on the hot engine parts.
The different models are explained as follows
1. Mode “1”: single pulse mode. In this mode, when the “ Pulse ” key is pressed, the instrument will send out a pulse with a pulse width of about 255 Ms.
2. Mode “2”: short pulse mode. In this mode, when the “ Pulse ”key is pressed, the instrument will send out 50 pulses with a pulse width of about 7 Ms.
3. Mode “3”: long pulse mode. In this mode, when the “ Pulse ”key is pressed, the instrument will send out 100 pulses with a pulse width of about 3.5 Ms.
4. Mode “4”: continuous pulse mode. In this mode, when the “ Pulse ” key is pressed, the instrument will continuously output pulses with a pulse rate of about 50 pulses per 1450 Ms and a pulse width of 7 Ms.
Specification
Power Supply:12V vehicle battery
Operation Environment:0-40°C, relative humidity < 80%
Storage Environment: -10°C ~50°C, relative humidity<85%
Test Cable Length: 41.5cm/ 16.3 inches
Product Size:146x81x28mm
Package:
1x Fuel Injector Tester
