Thin Pedal Riser Thin Wide Pedal Riser Effector Velcro Raise Bottom Raise For Fixing [114mm Wide]

We offer a wide variety of products, and the following precautions apply to some of them. Please note that they are listed for all products. 【Voltage Compatibility】Designed for Japanese voltage (90-110V). Using with a different voltage may cause malfunction. 【Plug Type】Japanese plugs (A or B type). Use a conversion adapter if needed. 【Transformers & Adapters】Transformers adjust voltage; adapters only change plug shape. Using an adapter without a transformer may damage the product. 【Liability】We are not responsible for damages caused by improper use, such as using the product without a transformer. A new member of the Thin Pedal Riser series, the Thin Pedal Riser 114mm Wide, has arrived. This Pedal Riser is the perfect accessory for raising slightly larger effects such as Strymon. The width and length are designed to be approximately the same size as Strymon's under panel. Not only Strymon, but also slightly larger effectors can be raised firmly. By using it horizontally, it is also possible to mount two mini-sized effectors. Adopts a raised amount of 14mm common to the series. Although the amount of elevation is modest at 14mm including Velcro, it has many conveniences unique to this size. For effect boards with frames such as the ARMOR and Kyoritz KC series, the effect board frame and jack may interfere, but this problem can be resolved with many effects by raising the jack by 14mm. Since the amount of elevation is not excessive, the lid can be closed with boards with low lid clearance, such as the Kyoritz EC-50 and Almor PS-3C, which are commonly used in Japan (they may come into contact with the sponge on the top lid) (not all combinations are guaranteed) When adjusting the height when lining up with tall effectors such as BOSS, or placing effectors front and back, you can set them naturally without raising them too high like conventional pedal risers. The main body is made of durable iron with a thickness of 1.6mm, and can firmly support even heavy effectors. Furthermore, the effector is securely fixed to the board with a strong Velcro tape finish with a slightly long bushy foot. There is no need to worry about misalignment while moving or playing. The four corners of the effector's ground surface are angled to allow protrusions such as rubber feet and screws to escape. This allows you to place the effector stably. Thin Pedal Riser 114mm Wide is an original product of GBD MUSIC. A new member of the Thin Pedal Riser series, the Thin Pedal Riser 114mm Wide, has arrived. This Pedal Riser is the perfect accessory for raising slightly larger effects such as Strymon.